IFB Washing Machine TUB REAR TYPE 5 WD ASSLY

The IFB Front Load Fully Automatic Washing Machine Rear Tub Assembly (Part Number: UF321MXPTR151 / Specification: Type 5 WD) is an authentic original equipment manufacturer (OEM) replacement outer drum component designed for select IFB front-load washers. Located inside the cabinet surrounding the rotating stainless steel inner drum, this rugged thermoplastic rear tub half houses the drive shaft and bearing housing. It acts as the primary water containment chamber while providing the structural anchor point for the rear suspension and motor drive system.

Key Features

• Type 5 WD Heavy-Duty Architecture: Engineered to support high-capacity front-load drum dynamics, enduring high-speed spin cycles up to 1200+ RPM without flex or vibration.

• Pre-Installed Bearing & Oil Seal Set: Includes factory-pressed high-grade ball bearings and a dual-lip rubber oil seal to protect against moisture intrusion and bearing washout.

• Integrated Stainless Steel Spider / Shaft: Features a robust cast-metal spider arm and steel drive shaft firmly embedded into the tub rear for secure drum rotation.

• Chemical & Thermal Resistant Polymer: Molded from high-density, glass-filled thermoplastic capable of withstanding aggressive laundry detergents, bleach, and high water temperatures up to 90°C.

• Precision Sealing Channel: Perimeter groove engineered for a watertight rubber tub gasket/seal fit between the front and rear tub halves.

Benefits

• Solves major washing machine failures such as loud rumbling/grinding noises during spin cycles (worn bearings), severe drum play, leaking water from the rear of the tub, or broken spider mounting points.

• Replaces cracked plastic tubs or seized bearings without needing to source individual bearing kits.

• Direct OEM replacement ensures 100% bolt-pattern alignment with the front tub half, counterweights, and cabinet suspension springs.

Applications Designed specifically for select IFB front-load washing machine models requiring Type 5 WD rear tub assembly part number UF321MXPTR151.

What's Included

• 1 x Genuine IFB Front Load Washing Machine Rear Tub Assembly with Pre-Installed Bearings and Shaft (UF321MXPTR151)

Usage Instructions

• Warning: Major repair requiring complete disassembly of the washing machine. Unplug the unit from power and disconnect water and drain hoses before starting.

• Remove the top panel, rear service cover, control panel, door boot seal clamp, front cabinet panel, concrete counterweights, shock absorbers, and suspension springs to extract the outer tub assembly.

• Split the front and rear thermoplastic tub halves by unfastening the perimeter clamp or screws.

• Transfer the inner stainless steel drum, motor assembly, heating element, and hoses to the new IFB UF321MXPTR151 rear tub.

• Apply waterproof silicone sealant to the tub gasket groove if required, clamp the tub halves together securely, and reassemble the machine in reverse order.

• Run a test rinse cycle to verify zero water leakage and smooth drum rotation.

Safety Instructions

• Exercise caution when lifting heavy concrete weights and drum assemblies; enlist a second person for safe lifting during disassembly and reassembly.

• Always isolate the machine from electrical power before opening the outer cabinet.

Care Instructions

• Use recommended descaling agents periodically and avoid overloading the machine beyond its rated capacity to prevent premature bearing wear.

Technical Specifications

Attribute	Specification
Brand	IFB
Model / Part Number	UF321MXPTR151
Component Type	Rear Outer Tub Assembly (Type 5 WD)
Appliance Type	Front Load Fully Automatic Washing Machine
Included Hardware	Rear Tub Half, Drive Shaft, Spider Arm, Bearings & Oil Seal
Material	High-Density Glass-Filled Thermoplastic & Stainless Steel
Country of Origin	India
Package Contents	1x Rear Tub Assembly with Pre-Pressed Bearings