LG Washing Machine Clamp,Tub

The LG Washing Machine Tub Clamp Assembly (Part Number: 4860EN3001E) is an authentic original equipment manufacturer (OEM) replacement hose clamping component designed for LG washing machines and washer-dryer combination units. Positioned around internal tub-to-pump bellows, drain hose fittings, or tub outlet ports, this specialized adjustable wire clamp assembly applies uniform 360-degree radial sealing compression. It prevents hoses from slipping or blowing off during heavy wash agitation and high-pressure drainage cycles, keeping all wastewater securely contained.

Key Features

• Adjustable Tensioning Screw & Retainer Nut: Features a threaded drive screw mechanism with a retaining bracket to allow precise torque adjustment and a secure hold.

• Heavy-Duty Spring Wire Band: Formed from high-tensile spring steel wire designed to maintain continuous radial clamping force across dynamic vibration and temperature shifts.

• Corrosion-Resistant Plated Coating: Finished with a protective anti-corrosion plating to resist moisture, detergent residue, bleach, and rust.

Benefits

• Solves internal tub water leaks, loose or disconnected drain lines, rattling clamps, or flooded laundry floors.

• Prevents hose detachment caused by heavy tub vibration and high spin-cycle forces.

• Direct OEM replacement guarantees exact wire loop diameter, screw thread pitch, and factory fitment.

Applications

Designed specifically for select LG front-load and top-load washing machine and washer-dryer combination models requiring part number 4860EN3001E.

What's Included

• 1 x Genuine LG Washing Machine Tub / Hose Clamp Assembly with Tension Screw (4860EN3001E)

Usage Instructions

1. Unplug the washing machine from the main AC electrical outlet and turn off water supply valves before starting repairs.

2. Remove the relevant cabinet panel (front, rear, or bottom cover) to access the target hose connection.

3. Loosen the tensioning screw on the old clamp using a Phillips screwdriver or nut driver, then slide it off the hose port.

4. Position the new LG 4860EN3001E clamp over the hose end, slide the hose onto the tub or pump fitting, and tighten the tension screw securely until firmly sealed.

5. Reassemble cabinet panels, restore water and power, and run a test cycle to confirm a leak-free seal.

Safety Instructions

• Disconnect main AC electrical power and ensure all water is drained before servicing internal hose clamps.

Care Instructions

• Avoid over-tightening the tension screw to prevent cutting into the rubber hose wall.

Technical Specifications

Attribute	Specification
Brand	LG
Model / Part Number	4860EN3001E
Component Type	Washing Machine Tub & Drain Hose Wire Clamp Assembly
Material	High-Tensile Plated Steel Wire
Adjustment Type	Threaded Drive Screw with Nut Retainer
Package Contents	1x Hose / Tub Clamp Assembly